Fitting the Switches into the Faceplate
|
A mock-up of the finished article was performed. None
of the switches below have been 'screwed' in, as we are checking for spots where
the holes need more filing.
Already Looking very sweet indeed.
You can see an extra modification, a custom fanbus, that will sit above the
keypad...it has
also been noted Wiring the PCB to the LCD I decided to use a 1x10 header plug, for the LCD end and
then split it into 2x4pin cables, there by not using the middle two pins.
This could of course fit either way, only resulting in the characters generated
by the switches being different.
This is as easy as it
gets....the length of the wires are determined (obviously) by the location of the LCD module |
